Tuesday, 15 August 2017

Types of ball valves

This type of ball valve is known as Cavity Filler Ball Valve. There are a few types of ball valves related to the attachment and lateral movement of the ball : 123. Do ball valves seal better than gate valves?


What is a standard ball valve? Why use a ball valve vs plug valve? A full port ball valve has an oversized ball so that the hole in the ball is the same size as the pipeline resulting in lower friction loss.

Flow is unrestricte but the valve is larger. There are two basic technologies for the design of ball valves , floating ball design and trunnion mounted ball design. In a floating valve , the ball is suspended in the flowing fluid. Trunnion valves have been introduced to cope with the size limitations.


The following are some typical applications of ball valves: 1. Air , gaseous , and liquid applications requiring bubble-tight service. Low-point drains and high-point vents in liqui gaseous, and other fluid services. Cooling water and feed water systems.

There are four general types of ball valves: full port , standard port , reduced port , and v port. Types of Valves Gate Valve. Most ball valves are of the quick-acting type , which requires a 90° turn of the valve handle to operate the valve.


But in case large size valve which required considerable force to open or close the valve , the gear-operated actuator is used. With this arrangement, a small handwheel is enough to operate a fairly large valve. Valves can be categorized into the following types , based on their operating mechanism. Ideal for quick shut-off, since a 90° turn completely shuts-off, compared to multiple 360° turns for other manual valves.


Engineering Laboratories, Inc. Find the Right Hydraulic Valves for the Job. They can handle slurries and dusty dry fluids. Gate valve is a sliding type of valve. In gate valves , the closing member is a metal gate.


Use of ball valve as control valve is suitable for service where precise control is not. Usually, gate valves are not preferred choice of control valves. Use of butterfly valve as control valve is recommended where service is.


Quarter-turn 2-way ball valves are by far the most common type of process control valve. They are 2-way (inlet and outlet), 2-position (open and closed) valves that are used for shut-off or isolation of a system, or a loop or component within a system.

Here are Two different pictures of ball valve. The first one is brass ball valve and the second is carbon steel ball valve and these are quick core return isolation valves. Ball valves are typically an isolation types of valves. Side entry or split body.


Check valve is used to stop back flow in a piping system. Rotary steball , butterfly an plug control valves types. When you turn the handle, it makes the ball swivel through ninety degrees, allowing the fluid to flow through the middle of it.


Ball Valves Long life and safe operation in tough services, from cryogens to highly corrosive fluids — these are the hallmarks of our comprehensive and respected ball valve portfolio. Float-less Type Fill Valve. Maximum safety and environmental protection are the driving factors in every design, achieved through corrosion-resistant materials, fire-safe testing, blowout.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.

Popular Posts