Tuesday, 19 September 2017

Hdpe pipe dimensions

Our pipes are continuously monitored throughout the entire manufacturing process to validate that they are in accordance with all applicable specifications. Certificates of Compliance are available upon request. Pipe sizes under 6” may be coiled at continuous longer lengths upon request.


Coiled pipe is available in diameters up to 3” and is available in 2and 5foot lengths. Larger pipe sizes and coil lengths are available on special request.

Temperature, Chemical, and Environmental use considerations may require use of additional design factors. This size and dimension chart is intended for reference purposes. HDPE can accomodate up to 1. Nominal Pipe Size (inch) OD (inch) GF Part No. The product’s physical properties make it applicable to open-trench, horizontal directional drilling, pipe-bursting and slip-lining installations. Hdpe Supply is your number one source for Hdpe Fittings, Hdpe Pipe , and Fusion Equipment.


We sell polyethylene pipe , butt fittings, socket fittings, electrofusion fittings, and fusion equipment. Use this guide to help you find the pipe and fitting sizes you need!

MasterCar Discover, AmEx, PayPal. Budget-friendly and project-tough. Tested by our own product experts! For Your Business Needs. Hdpe Pipe (High Density Polyethylene Pipe ) is har light, solid pipe with a smooth inner and outer surface.


CorrUgated exterior adds strength. The pipe diameter of 6mm or less. This provides major cost savings, when compared to different pipe systems, some of which require glued fittings, restraints or thrust blocks for even minor changes in direction.


The most commonly used diameters usually begin from 75mm (D) upwards and PN or higher. PN IO- 0kPa pipe yields a PN 6-6kPa fabricated fitting. Readily available diameters range from 20mm to 800mm outside diameter.


The standard stocked length of Sclairpipe pipe is feet, in sizes above 4” in diameter with longer lengths available on request. All dimensions are in inches unless otherwise specified. Pressure ratings are based on load durations of years at a service temperature of 73. Can be connected with compression fittings sizes 1mm. Sizes 110mm usually connected with a combination of butt-fusion welding, stubs and backing rings.


It easily bends, allowing trenchless installation.

Longer lines can be installed so fewer joints are needed. Heat fusing creates extremely strong joints, which means fewer leaks in the future. Bar, in conjunction with compression, buttweld or electrofusion fittings.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.

Popular Posts